Saftronics GP5 Series Manual de instrucciones Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 11
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5
Page 6
© 2000 Saftronics, Inc.
S
TART-UP GUIDE
GP5 / FP5
www.saftronics.com
Example 3: Remote Start/Stop (3-wire) & Speed changes via the Keypad
This mode is commonly used when a inverter is replacing existing equipment such as an across the line starter and
the application requires minimal to no speed changes.
Operation
The frequency reference (speed change) is programmed into parameter U-01.
By momentarily closing push-button (PB1), while push-button (PB2) is closed, the inverter will run up
to the frequency reference set into U-01.
By opening push-button (PB2) at any time, the inverter will stop.
When switch (SW1) is in the open position the motor will run in the forward direction. If the
switch (SW1) is closed, the motor will reverse direction.
When the LOCAL/REMOTE key is pressed, the inverter will act as Example 1.
Table 3: Programming Needed for Start/Stop (3-wire) and Speed Changes via
the Keypad
retemaraPyalpsiDnoitpircseD
100N
drowssaP
9
tesereriw-3amrofreplliwretrevniehT
:NOITUACyrotcafriehtotsretemarapllastesretemarapsihT
retrevniehtnehW.tsoleblliwsgnittessuoiverplladnasgnittes
.1foeulavaotsnruterretemarapeht,teserehtsetelpmoc
100N
drowssaP
3
.retrevniehtniretemarapllaseccaot,3foeulavaotegnahC
200N
tceleSedoMrepO
RPO=FERMRT=QES
aivpots/tratsehtstesdnadapyekehtaivycneuqerfehtsteS
.snottub-hsuppots/tratsetomer
ALF
ALFdetaRrotoM
Ax.x
ehtstessiht(.etalpemanrotomehtmorfspmadaolllufehtretnE
)levelnoitcetorprotom
10-1U
feRycneuqerF
zH.XX=10-U
ybelbatteS.)deeps(ecnereferycneuqerfderisedehtsteS
gnisserpRETNE/ATADehtesU. dna ehttesotsyekworra
sserpnehtdnaycneuqerfRETNE/ATAD.
FC
G
FI
FV
FS
S1
S2
S5
S4
S3
S6
SC
GP5/FP5
Control
Wiring
Shield to
Terminal G
(PB1)
(PB2)
Start
Stop
SW 1
Forward
Reverse
Start
Stop
FWD/
REV
For more info on
the multi-function
inputs ref. page
78 in the GP5/
FP5 Instruction
manual
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11

Comentarios a estos manuales

Sin comentarios